1. 表面需經過預先處理
   速能牌快乾膠必須在完全清潔的表面方可發揮其最大的效應，所以，為了發揮最大的使用強度，請在使用前徹底清除接著表面的水分、油漬、銹蝕及其他在表面的髒污。
2. 接著方法
   使用少量的速能牌快乾膠在接著物表面，再將兩接著物表面重疊在一起放置於固定的位置。使用的快乾膠越薄，接著強度越大。

處理方法 

使用中

• 刺激眼睛，一經接觸，短時間內會黏著皮膚。
  如果不慎接觸眼睛，必須以大量的清水沖洗並立即延醫治療，若不慎接觸皮膚, 可在溫暖的肥皂水中輕輕搓除或使用如丙酮、指甲去光水等溶劑去除。
• 不可在工作中使用橡膠及棉質手套。 橡膠手套一經接觸膠水會立刻黏著；而多孔性的棉質手套會吸收膠水，而且把手套黏著于皮膚上，發生化學反應釋放出大量熱能導致嚴重灼傷。
• 當需要大量或必須長時間使用瞬間膠時，請在通風良好的工作場所中施行。
• 速能牌快乾膠可應用於大部分的材質，惟PP、PE、氟化物樹脂除外。

儲存方法

• 請放置於孩童無法接觸之處。
• 避免陽光直射。
• 放置于陰涼乾燥處。

1. Surface Treatment
   ULTRA BOND cyanoacrylate adhesive series demonstrates its full efficiency on thoroughly cleaned surfaces. Therefore, completely remove moisture, oil, rust, mold release agent and other contaminants from the surface is the essential factor for ensuring satisfactory bonding strength.
2. Bonding Method
   Apply small quantity of ULTRA BOND series on the surfaces to be bonded, lap them together to achieve uniform and thin application. Then fix them securely at the prescribed position. The thinner adhesive application, the stronger bonding strength be obtained.

• EYE IRRITANT, BONDS SKIN IN SECONDS
  In case of eye contact, the eye should be copiously flushed with water and medical aid sought immediately, when skin contact occurs, the adhesive should be removed by soaking in warm, soapy water or by treatment with solvents such as acetone or nail polish remover.
• Do not use rubber or cloth gloves. Rubber gloves will bond when brought in contact with the adhesive and porous cotton gloves will absorb the adhesive then bond the gloves to the skin, and release a lot of chemical reaction heat to cause serious burns.
• When using it in large quantity or over a long period of time, be careful to ensure adequate ventilation of working environment.
• ULTRA BOND series virtually with all materials except for PP, PE, or Fluoro resin.

• Keep away from reach of children.
• Keep away from direct sunlight.
• Store in cool and dry place.